RESINS
Our Resins are just as wonderful as our regular incense…The only thing missing from our resins is a stick.
Instructions: Remove one charcoal from its package and hold the charcoal with long-handle tweezers or pliers. While still holding the charcoal in tweezers/pliers, Place an open flame for about 20 seconds and place the lit charcoal inside one of our charcoal holder. It's always best to place charcoal on a bed of sand. Sand can reduce the risk of the container cracking due to extensive heat charcoal produces, this holder should not be placed on any type of flammable surface.. Once the flame has completed covered the charcoal (you will notices the edges turning gray), using a spoon add a small amount of resins onto the top of the charcoal. Allow the resins to completely burn it scent out. Repeat in the same manner until you have enough. Charcoals may continue to burn for up to 2 hours. To extinguish the lit charcoal by slowly pulling the charcoal out of the holder and submerse in water.
The Charcoal disks used for incense burning is NOT the same used for your backyard barbecue grill.
DO NOT USE BBQ Charcoals ! Using BBQ charcoal indoors may produces noxious fumes. DO NOT THROW A LIT CHARCOAL INSIDE A WASTEBASKET/TRASH CAN! Never hold the charcoal with your fingers - always use long handle tweezers, thongs or pliers.
|
